Similar Projects
Reported | 04/02/2022 12:00 AM |
Project Title | Elderly Center Kitchen Range Hood Replacement |
Physical Address | View project details and contacts |
City, State (County) | Peach Springs, AZ 86434 (Mohave County) |
Category(s) | Single Trades |
Sub-Category(s) | HVAC |
Contracting Method | Competitive Bids. |
Project Status | Request for Proposals (RFPs) |
Bids Due | View project details and contacts |
Estimated Value | |
Plans Available from | Municipal Agency |
Owner | View project details and contacts |
Architect | View project details and contacts |
Description | 1. Remove existing hood, ductwork and roof mounted exhaust fan 2. Assess existing roof curbing for removal and replacement or for repair and re-use as noted in No. 5 below. 3. Description: provide all labor, materials, equipment, and services necessary to furnish and install Type I “Ansul” range hood and ventilation unit, including all ductwork, blowers, fire suppression system, master electric controls and filter sections for a complete and operational system suitable for Therma-Tek Model No. TMD72-36G-6-2, medium duty range (see attached specs). Items not listed but required due to local codes or operational requirements shall be included under base bid. Unit shall be UL listed and labeled. 4. Hood: the hood shall be double shell type, 18 gauge stainless steel inner liner with 18 gauge galvanized outer liner with satin finish stainless steel on the entire outer shell including facing, ends, and slots. Fabrication will be in accordance with NFPA No. 96 requirements and bear the NSF seal and shall be constructed in accordance with the International Building Code. All grease filters shall be AFI rated. 5. Ventilation: the roof mounted ventilation unit including all components shall be fully factory assembled and wired in accordance with the NEC. Heating and filter sections will be one integrated unit, mounted on adjustable supports for post mounting. An insulated steel wall roof curb is part of the furnished system. Master disconnect switches and wiring to the master electric panel will also be included. All duct work will be 16 gauge galvanized welded exhaust, and 18 gauge galvanized supply, conforming to NFPA No. 96. 6. Exterior surfaces of all roof equipment will be weatherproof enamel coated. |
||
Details |
|
||
Bidder's List | View project details and contacts | ||
Prospective Bidders | View project details and contacts | ||
Project Documents |
Engineered Spec Sheet Architectural Plans Other Documents |