Masonry and Concrete Repair Services

1. Removal of deteriorated materials to be replaced 2. Preparation of existing surfaces to have new materials placed on, in or next to them 3. Block and brick laying that shall match existing coursing 4. Using the proper mortar for the particular job application 5. Do masonry and block work level and plumb 6. Build block and masonry to accommodate pipe, duct or other required openings to industry standards including cutting of masonry or block to provide a continuous pattern. Cut edges shall be concealed 7. Preparation of steel lintels prior to installation with rust inhibiting finishes 8. Installation of steel and precast concrete lintels, 9. Installation of ties and anchors 10.Installation of embedded flashing at wall bases or above openings at lintels 11.Installation of reinforcing, 12.Installation of anchoring in masonry or block walls at the tops to structure above 13.Construct masonry and block walls to provide weeps at base and proper cavity drainage 14. Concrete placement for brick and block to bear on, 15.Placement of concrete in block for reinforcing 16.Selection of materials to match surrounding existing materials 17.Protection of sills, ledges, projections, door and window frames and newly installed masonry from mortar droppings 18.Cleaning of deteriorated mortar at joints and repointing of the joints. Joints shall be stuck to match existing joints surface. 19.Clean up of mortar/grout stains, efflorescence, and other stains from new masonry and concrete block 20. Clean up of surfaces from all traces of masonry and block work having been done

Division 03 -	Concrete, Cast-in-Place Concrete.
Division 04 -	Masonry, Common Work Results for Masonry, Masonry Mortaring, Unit Masonry.