Water Treatment Plant No. 2 Treatment and Disposal Improvements Design Package 2 - Deep Injection Well

Construct: one Class I injection well (IW-1), tubing and packer design with a final casing string of 26-inch outside diameter and total open-hole depth of 3,500 feet below pad level that may be permitted to accept an injection rate of approximately 9.69 million gallons per day (MGD) including the installation of wellhead components suitable for the connection and operation of a completed system; one associated dual-zone deep monitor well (DZMW-1) including the installation of wellhead components; four water-table monitor wells that will be either plugged and abandoned in place or completed with flush-mounted vaults and lockable caps at the end of the project; concrete slabs for well pads; secondary containment, waste brine storage tank, piping and pumps; asphalt and shellrock access road; and all electrical, instrumentation, piping, valves, pumps, paving, general civil site and other appurtenances for a complete fully functioning system.

Division 02 -	Existing Conditions, Subsurface Investigation.
Division 03 -	Concrete, Cast-in-Place Concrete.
Division 22 -	Plumbing, Plumbing Piping, Plumbing Equipment.
Division 26 -	Electrical, Instrumentation and Control for Electrical Systems.
Division 33 -	Utilities, Water Utilities, Water Utility Distribution Piping, Water Utility Distribution Equipment, Water Utility Pumping Stations, Wells.
Division 44 -	Pollution and Waste Control Equipment, Water Pollution Control Equipment.