Electrical Work for Security Camera Installation

Qty. 3 – Meter Bases and Disconnect/Load Center. Load Center must be at least 4 circuit (breaker spaces). This will be a complete change out to a new service. New weather head and conduit. The new services will be replacing non-metered disconnects for existing pole lights. Wiring for the existing Pole lights must be reinstalled on their own breaker in the new load centers. All must meet Ameren specifications. The new meter bases are to be installed at: - 1022 Wright Drive-west side of building - 620 Wright Drive-south side of building - 1030 Sadler-west side of building Qty. 3 – New Poles, these will be installed at: -1010 Sadler ID as Pole “E” on map - At least 30’ above ground level. Must align with pole “B”. -648 Robnett ID as Pole “D” on map – At least 50’ above ground level. Must align with pole “B”. -1030 Sadler ID as Pole “B” on map – At least 50’ above ground level. This Pole must align with Pole “A” “C” and “D” as marked on the map. Must have a line of site with each other. No obstructions. All new poles will have their own circuit. They will be powering cameras and Wi-Fi. Existing pole lights will be on a separate circuit. Supply power will be ran in conduit to each new pole. Wire must be sized for length of run to prevent voltage drop. Qty. 3 – Metal weatherproof enclosure, with hinge cover and securable latch. Dimensions 12”x 12” x 8” deep. Sizes can be discussed and adjusted if availability is a problem. You will need to install a 110 volt grounded duplex receptacle, low profile, mounted on the inside vertical side wall. The enclosures will be mounted on poles “C” “D” and “E” as marked on the map. Qty. 1 – Metal weatherproof enclosure, with hinge cover and securable latch. Dimensions 18” x 18” x 12” Deep. The enclosure will be mounted on pole “B”. You will need to install a 110 volt grounded quad receptacle, mounted on the inside vertical side wall. All new metal enclosures will be mounted at a height of 10’ from the ground to the bottom of the enclosure. Ameren specifications must be followed. A meeting with Ameren Field Engineer will be required as well as a meeting with camera installer before work is to begin. MCHA is to be notified of this meeting and be present for the meeting(s). Pole “A” – is an existing pole with power and internet already installed. No work required. Pole “B” – is a new pole located in the courtyard North of 1030 Sadler. It will require service power and an enclosure to house several pieces of equipment. Pole “C” – is an existing pole but will require an enclosure. Pole “D” – is a new pole. It will require service power and an enclosure. Position can be moved to dodge the water and gas mains that are there. Pole has to stay in that area. Pole “E” – is a new pole. It will require service power and an enclosure.

Division 26 -

Electrical.