Fire Station #7 Floor Replacement

Fire Station #7 Floor Replacement For additional information, contact Ricky Gladney, Buyer, at (229) 431-3211. Submit all questions via email to; rgladney@albanyga.gov cc: jswilliams@albanyga.gov, kross@albanyga.gov The deadline for questions is January 9, 2023, at 2:30 p.m. questions received after this deadline may not be answered. To remove the floor slab/drive area and excavate the subgrade material approximately eight (8) inches. The replacement of the subgrade material and concrete slab should be replaced in accordance with the geotechnical report provided by TTL, Inc, the structural report provided by Fletcher Engineering and the approved construction drawings. Compaction testing and written report will be required of the subgrade material prior to concrete slab being poured/installed. Fire Station #7, located at 2203 Leonard Ave, Albany, GA 31705, needs new concrete floor installed in both bays and drive areas due to a failing aggregate base and a newer heavier truck the Fire Department now uses. Bay 1 has been partially excavated and tested with several other samples taken and the results contained in the bid documents. It is required that the station remain open during the rehabilitation work. To accomplish this, each bay will be repaired individually, and care must be taken to ensure the fire fighters on duty have a safe ingress and egress while accessing all equipment and vehicles located in the open for use bay. The following is a summary of the procedures: 1. Remove the floor slab/drive area and excavate the subgrade material approximately eight (8) inches. The replacement of the subgrade material and concrete slab should be replaced in accordance with the geotechnical report provided by TTL, Inc, the structural report provided by Fletcher Engineering and the approved construction drawings. 2. Replace and/or repair any plumbing lines, discharge lines from the oil/water separator prior to placement of finished concrete. 3. Replace and/or repair any electrical lines prior to placement of finished concrete. 4. Compaction testing and written report will be required of the subgrade material prior to concrete slab being poured/installed. 5. Replace/repair brick veneer that has previously fallen and/or falls during time of excavation of the existing concrete. 6. Replace and finish concrete with a grade suitable for the new heavier trucks the City is now using

Division 09 -

Finishes, Flooring.