Fuel Facility Safety and Security Improvements

1. Fence to be relocated (see Exhibit 1) per plan 2. Two 24" Cantilever Gates with L3 Viking openers 3. Removing and replacing chain link fence as shown on Exhibit 1. Existing post being removed to be cut at ground level and filled with concrete. 4. Install (3) 208V circuits for (3) new gate operators and (1) 120V control circuit to new data control cabinet from existing panel in gate house. Dig ditch in soil along south side and add (2) ground junction boxes to terminate bores. Connections to be made with weatherproof connectors. Terminate 120V circuit in new control cabinet to be supplied by others. Pull new circuits through bores and terminate (3) new gate controllers/openers. Pull 120V circuit to new card reader stand and terminate. Install 1Dual Pedestal Aluminum Reader Stand with 4" square at 75" and 55" with 12" base that can accept an LED light at the top by contractor (reader and LED light will be provided by owner) 5. Cut and remove concrete at (3) locations as necessary for directional bore. Replace concrete after directional bores complete. Concrete patch includes a single mat of rebar tied into rebar doweled into adjacent concrete with epoxy. 6. Coordinate with VCDD District Property Management on scheduling work due to the Fuel Site being operational. 7. Contractor will be responsible for all boring and concrete work involved with running conduit to the gate operators and HID card reader for electrical and network technology. 8. Contractor will work in conjunction with The Villages Technical Solutions Groups for install of network technology and Royce Integrated Solutions with HID card reader/pedestal.

Division 27 -	Communications, Common Work Results for Communications.
Division 28 -	Electronic Safety and Security, Common Work Results for Electronic Safety and Security.
Division 32 -	Exterior Improvements, Fences and Gates.