ADA Curb Ramps, Milling, Hot Mix Asphalt & Lighting, Chip Seal, Cape Seal, Micro-surfacing, Ultra-thin Bond Wearing Course

Proposed Work Consists of 31.0640 Miles of Ada Curb Ramps, Milling, Hot Mix Asphalt & Lighting, Chip Seal, Cape Seal, Microsurfacing, Ultra-thin Bond Wearing Course Length: 31.0640 Located Nd 1804 (University Drive), Signalst N to Nd 810 (Bismarck Expressway) - Bismarck And Nd 1804, Cmc 1510 N to Signal St (S of Bismarck) Bid Range - $8,000,001 to $9,000,000 Prequalification is required for all bidders submitting a bidding proposal form. Prequalification is required annually. Prequalified contractors who wish to renew their prequalification must submit a complete "Contractor's Prequalification Statement" by July 1 of each calendar year. Bidders who are not currently prequalified must submit a complete "Contractor's Prequalification Statement" at least 10 business days prior to the date of the bid opening. Information is available from the Construction Services Division of the North Dakota Department of Transportation. Contractor's License--A contractor is not required to have a license from the state of North Dakota before bidding on any project, however, no contract will be awarded unless said contractor holds a current North Dakota license in the class within which the value of the contract falls. Contractors are required to meet the provisions of the Contract Work Hours and Safety Standards Act on the federal aid projects, are required to meet the Fair Labor Standards Act on all projects, and are required to pay any minimum wage rates set forth in the proposal form. A bid guarantee is required by Section 24-02-20, NDCC. The bid guarantee may be a bid bond equal to 10 percent of the full amount of the bid or a cashier's check of the bidder on a solvent bank equal to 5 percent of the bid. Bid bond shall be on the department form SFN 14196. Prior arrangements may be made with the department to file bid guarantees in advance. The Department of Transportation and all bidders are obligated to affirmatively ensure that in any contract entered into pursuant to this advertisement, minority or women's business enterprises will be afforded a full opportunity to participate and to submit bids in response to this invitation and will not be discriminated against on the grounds of race, religion, color, sex, age, or national origin in consideration for an award. Where applicable the contractor must fulfill all special provision requirements for utilization of Disadvantaged Business Enterprises. The right is reserved to reject any and all proposals, to waive technicalities, or to accept such as may be determined to be for the best interests of the state. NDDOT - Job No - 23223 - ADA Curb Ramps, Milling, Hot Mix Asphalt and Lighting, Chip Seal, Cape Seal, Micro-surfacing, Ultra-thin Bond Wearing Course *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. Minority Goal : 0.4%

Division 03 -

Concrete, Cast-in-Place Concrete.