Walk-in Freezer for Senior Center

The outside walk-in freezer is to be furnished and installed. As seen in Figure 2 the outside walk-in freezer is to be remote/unattached to building with floor. The freezer is to be a 10’ X 14’ walk-in with a 60” wide X 78” tall single door, internal ramp, 5-foot wooden exterior ramp (no greater than 1:12), interior lighting, an internal panic hardware (inside), and a minimum 3hp refrigeration system to maintain -10 degrees F. Any drains are to drain to grade, no areas of ponding are to be created. All bids must include a new 6-inch-thick 3500 psi concrete slab with # 4 rebar at 6-inch on center each way, all required electrical work, permits, inspections, and factory recommended start up and commissioning. Testing must be done with the backup generator to ensure the freezer remains running during a power outage. The freezer will be wired through conduit into the building to the existing electrical panel located inside the Senior Center.

Division 11 -

Equipment.