Don A. Christiansen Regional Water Treatment Plant 15-MG Reservoir Seismic Evaluation Condition Assessment and Improvements Project

The Work consists of construction of the Don A. Christiansen Regional Water Treatment Plant 15 MG Reservoir, including the following: (1) replace the existing 48" butterfly valve, torque tube, floor stand, and actuator at the 15 MG Reservoir outlet sump; (2) replace the existing 6" mud valve, stem extension, and supports at the 15 MG Reservoir outlet sump; (3) replace the existing baffle curtains in the same configuration and install a new concrete curb structure to contain the baffle ballast; (4) replace existing FRP washdown piping with SCH 80 PVC piping; (5) clean and caulk existing construction joints of both the 15 MG and 2 MG reservoirs; and (6) repair corrosion and/or spalling on concrete and mechanical piping as needed. Central Utah Water Conservancy District reserves the right to reject any or all Bids, to waive any formality, or technicality in a Bid, and to make Award to the lowest responsive, responsible Bidder if deemed in the best interests of the Owner, or the public good; or as being nonresponsive to the requirements set forth herein, in Section 00 21 13, Instructions to Bidders, or on the grounds that a prospective Contractor is not qualified. Any Bid received from a Bidder who was not invited to bid or received after the closing time for receipt of Bids will be returned unopened. Est. Completion Date: June 1, 2023 Pre-Qualification: Yes Board of Trustees Approve Award October 26, 2022 SITE OF WORK: The site of the work is located at the Don. A. Christiansen Regional Water Treatment Plant at 1120 Cascade Drive, Orem, Utah. Completion- April 15, 2023 - 48" Butterfly Valve Installed and Operational May 15, 2023 - Substantial Completion for the Project June 1, 2023 - Final Acceptance of the Project

Division 02 -	Existing Conditions, Subsurface Investigation.
Division 03 -	Concrete, Precast Concrete.
Division 04 -	Masonry, Unit Masonry.
Division 05 -	Metals, Structural Metal Framing, Metal Fabrications.
Division 06 -	Wood, Plastics, and Composites, Rough Carpentry.
Division 07 -	Thermal and Moisture Protection, Dampproofing and Waterproofing, Thermal Protection.
Division 08 -	Openings, Doors and Frames, Windows, Hardware.
Division 09 -	Finishes, Painting and Coating.
Division 10 -	Specialties, Signage, Compartments and Cubicles, Emergency Aid Specialties, Fire Protection Specialties, Storage Assemblies.
Division 11 -	Equipment, Laboratory Equipment.
Division 14 -	Conveying Equipment.
Division 21 -	Fire Suppression, Fire-Extinguishing Systems.
Division 22 -	Plumbing, Instrumentation and Control for Plumbing, Plumbing Piping, Plumbing Equipment, Plumbing Fixtures.
Division 23 -	Heating, Ventilating, and Air Conditioning (HVAC), Instrumentation and Control for HVAC, HVAC Air Distribution.
Division 26 -	Electrical, Instrumentation and Control for Electrical Systems, Interior Lighting, Emergency Lighting, Exit Signs, Exterior Lighting.
Division 27 -	Communications, Structured Cabling, Data Communications, Voice Communications, Distributed Audio-Video Communications Systems.
Division 28 -	Electronic Safety and Security, Electronic Access Control and Intrusion Detection, Access Control, Intrusion Detection, Electronic Surveillance, Electronic Detection and Alarm.
Division 31 -	Earthwork, Erosion and Sedimentation Controls, Earthwork Methods.
Division 32 -	Exterior Improvements, Bases, Ballasts, and Paving, Flexible Paving, Asphalt Paving, Rigid Paving, Concrete Paving, Curbs, Gutters, Sidewalks, and Driveways, Fences and Gates, Turf and Grasses.
Division 33 -	Utilities, Water Utilities, Storm Drainage Utilities, Ponds and Reservoirs, Electrical Utilities, Communications Utilities.
Division 35 -	Waterway and Marine Construction, Shoreline Protection, Waterway Construction and Equipment.
Division 44 -	Pollution and Waste Control Equipment, Common Work Results for Pollution and Waste Control Equipment, Air Pollution Control, Noise Pollution Control, Odor Control, Water Pollution Control Equipment, Solid Waste Control and Reuse, Waste Thermal Processing Equipment, Fluidized Bed Combustion Equipment, Rotary Kiln Incinerators, Pyrolysis Equipment, Hazardous Waste and Medical Waste Incinerators, Heat Recovery Equipment for Waste Thermal Processing, Synthesis Gas Cleanup and Handling Equipment.