Similar Projects
| Last Updated | 02/21/2020 01:35 PM |
| Project Title | Sutton Road H-Frame Transmission and Distribution Installation |
| Physical Address | View project details and contacts |
| City, State (County) | Rocky Mount, NC (Edgecombe County) |
| Category(s) | Single Trades |
| Sub-Category(s) | Electric |
| Contracting Method | Competitive Bids. |
| Project Status | Results |
| Bids Due | View project details and contacts |
| Estimated Value | $104,176 |
| Plans Available from | |
| Owner | View project details and contacts |
| Architect | View project details and contacts |
| Description | 1. Installation of 3. 85-foot steel transmission poles 10.5 foot deep per pole with rock at approximately 7 foot below ground. 2. Installation of 1. 85-foot steel transmission pole with no anticipated rock at location. Duke Energy has a three-phase feeder circuit on pole which will remain energized but spread for installation of new 85 foot transmission pole. All other circuits will be de-energized. 3. Installation of four distribution underground feeder circuits out of substation. Approximately 1500 feet of 750 MCM underground aluminum primary. Substation will be de-energized. 4. Installation of 16. 600 Amp Disconnect Switches 5. Installation of approximately 2500 feet of de-energized transmission 1272 AAC wiring and static wire. 6. Installation of approximately 4000 feet of de-energized distribution primary feeder 336 ACSR wiring 7. Removal of two 45-foot distribution primary pole and de-energized primary conductor all conduit should be removed above 2-foot subgrade. 8. Removal of 9000 feet of de-energized transmission and distribution primary conductor and top four poles over energized Duke Power primary feeder three phase circuit. 9. The Contractor awarded the contact shall be responsible for transferring all de-energized transmission primary conduct, static wire, guying and installation of new anchoring as needed for this project. 10. The Contractor awarded the contact shall be responsible for transferring all energized distribution primary, neutral conduct, guying, anchoring, transformers, secondary and lights as needed for this project. 11. The Contractor awarded the contact shall be responsible for transferring all communication wiring that's not deemed complex by Energy Resources representative without additional cost. Cost should be included in the total project post. 12. The Contractor awarded the contact shall be responsible for landing, making connections, and terminating all transmission and distribution conduct on this project. |
||||
| Details |
|
||||
| Bidder's List | View project details and contacts | ||||
| Prospective Bidders | View project details and contacts | ||||
| Project Documents |
 Engineered Spec Sheet  Architectural Plans  Other Documents |
