Similar Projects
Stormwater Management Products and Services
Bidding
Harrisburg, PA

44--Fuel Cell Breathing Air Purification System
Bidding
Middletown, PA 17057

Truck-Tractor and Trailers
Post-Bid
Harrisburg, PA

Wireless Network Equipment
Post-Bid
Middletown, PA

Road Surface Patching Equipment - SUPP
Results
Harrisburg, PA

Rental of Catch Basin Cleaner and Sweeper Units
Results
Middletown, PA

Acquire Snow Removal Equipment
Post-Bid
Middletown, PA

Fixed Automated Weather Station
Results
Halifax, PA

Secure Storage Vault
Post-Bid

Dental Lab Chairs and Equipment
Results
Harrisburg, PA 17110

Forestry 500-Gallon Wildland Fire Flatbed
Post-Bid
Harrisburg, PA 17101

Compact-Crane Lift System
Results

CDL Commercial Equipment Repairs
Post-Bid
Harrisburg, PA 17110

35-X162732 Mira Ultra Leak Detection System
Term Contract
Results
Less than $47,500 est. value
Harrisburg, PA 17110

Service Bay Lifts & Compressors
Term Contract
Post-Bid

Reported 08/01/2019 12:00 AM
Project Title

Refurbish Plows

Physical Address View project details and contacts
City, State (County) Harrisburg, PA 17101   (Dauphin County)
Category(s) Single Trades
Sub-Category(s) Equipment
Contracting Method Competitive Bids.
Project Status Bidding
Bids Due View project details and contacts
Estimated Value
Plans Available from State Agency
Owner View project details and contacts
Architect View project details and contacts
Description 1. Sandblast to Commercial Blast specifications so that all oil, grease,dirt, rust scale, and foreign matter are completely removed from the surface and all rust, mill scale and old paint are completely removed by abrasive blasting except for slight shadows,streaks or discolorations caused by rust stain, mill scale oxides or slight,tight residue of paint or coating that may remain. If the surface is pitted,slight residue of rust or paint may be found in the bottom of pits: at least two/thirds of each square inch surface area shall be free of all visible residue and the remainder shall be limited to the light residue mentioned above. 2. Clean and prep all surfaces by means of solvent wipe using xylene or toluene. 3. If any cracks or holes are discovered, the vendor should contact the Pennsylvania Turnpike Commission for instructions before painting. 4. Prime with one (1) coat of industrial epoxy rust inhibitive primer to a dry coat of at least 2 mils thickness. The following primer should be used or an equivalent. If an equivalent is used, it must be approved by thePennsylvania Turnpike Commission. 5. Paint with the following polyurethane paint or an equivalent to a dry thickness of at least 2 mils. If an equivalent is used, it must be approvedby the Pennsylvania turnpike Commission.
Details
Division 11 - Equipment.
Bidder's List View project details and contacts
Prospective Bidders View project details and contacts
Project Documents
 Engineered Spec Sheet
 Architectural Plans
 Other Documents