Traffic Cone Setters/Retrieval Units

Unit shall be constructed to fully accommodate an upper structure that measures 94 inches wide by 36 inches deep. Understructure frame shall be constructed using 2” X 2” X 1/4” minimum square steel tubing. Center rail shall use the existing chassis receiver tube as a mounting point to the truck. Successful vendor shall supply receiver tubes to be universally mounted to the outboard sides of the existing truck hitch assembly to accommodate the remaining two evenly spaced rails. At the platform side of the rails, there shall be an adjustable plate, properly welded and gusseted to each of the three rails, measuring 5” X 11” X ½” with holes drilled that mirror a Wallace Forge receiver part number RE8511. A Wallace Forge receiver, part number RE8511 (No Substitute, Standardization) shall be supplied for center platform connection to the trucks existing receiver. There shall be two additional receivers supplied for the outer rails that has an adjustable plate measuring 5” X 11” X ½” with holes drilled that mirror a Wallace Forge receiver part number RE8511, they shall have a 2” X 2” X 1/4” minimum square steel tube properly welded and gusseted to each plate. There shall be a minimum of 12 – 1/2” grade 8 bolts, washers and lock nuts supplied that are of sufficient length to attach the 3 receivers to the platform adjustable brackets. Rails are to be continual lengths to the rear of the platform for stability. Three evenly spaced cross members and end perimeters shall be interlaced with long members. There shall be two skid plates mounted at each end of the platform to prevent damage to the platform when stored, and to allow a forklift to pick up platform. Skid plates shall be braced in the center. Skid plates shall allow for 3 inches of clearance between the ground and the bottom of the platform. All Joints shall be fully welded. Successful vendor shall supply one pin with cotter / hair pin to attach platform receiver to the truck. There shall be two lift brackets mounted to the rear side of the platform, they shall be made of 3/8” thick steel and bent inward not to exceed the 1 1/2” aluminum tubing with a 2” X 2” hole. There shall be two lift eyes on the front side of the platform that are incorporated into the outer receiver bracket gussets with a 2” X 2” hole.

Division 10 -

Specialties, Signage.