Car Wash

Line Item 0001: Automatic Car Wash System (Brush/Friction Type) Unit: Each (EA) Quantity: 1 The new car wash system must fit in the existing equipment room and main tunnel (see pictures listed in attachments # 2 through #19) within the following dimensions: Main tunnel: Length: 55 ft. Width: 15 ft. Height: 18 ft. 8 inches from floor to the ceiling; 17 ft. 7 inches from floor to the bottom of the support rafters; 14 ft. 7 inches from floor to the bottom of the garage door support structure Equipment room area: Length: 55 ft. Width: 4 ft. 7 inches Height: 36 ft. 7 inches high wall for mounting the machine The automatic car wash system should include the following salient characteristics: - System Voltage - 208VAC 60Hz 3-Phase - Pumping Plant Voltage - 208-240VAC 60Hz 3-Phase - Stainless Steel Doors - LED instructional lights - Remote display/keypad - Foam top and side brushes, - Off-board high pressure pumping plant - Contouring high pressure boom - 28 zero-degree turbo nozzles - Chemical injection system - Shampoo and foaming presoak - High output on-board presoak heater - Flood rinse - Low pressure rinse system with spot free controls - Frost protection -Sensor pad treadle - Extended rotation of top boom mounted turbo nozzles to hit rear of vehicle at 90 degree angle - Customer instruction sign (English) - Reset instruction sign (English) - High entry curved guide rails with caps - Guide rail warning posts and sign - 14 raised yellow reflective markers - Horizontal Brush Splash Guard - Undercarriage Wash with Flat Cover - Undercarriage Wash Activation System - Rocker Panel Applicator System - Clear coat Applicator System - 1.5hp Spot Free Rinse On-Demand Pump - Remote Monitoring - On-Board Air Drying System - Energy Chain Feed System - Open - track to wall from 27" to 41" - Track - 28' Low Profile - Track - 4' Extension Low Profile - Guide Rails - 10' Low Profile - Water Softener (single, 1.5" connect, 120,000 grains) - Angled Standard Height Base (32.5") - All-Inclusive 1-Year Labor, Parts, and Maintenance Agreement This acquisition includes the removal of the current car wash system, the Mark VII Car Wash System and Con-Serv Water Recovery System, in its entirety. The following procedures are the responsibility of the vendor: a) Complete a purge of any residual chemicals for the current car wash system. b) Dismantle the current car wash system. c) Remove the current car wash system from the car wash tunnel and machine room and stage it in a designated location in the parking lot. This acquisition includes the installation of the new car wash system. The following installation procedures are the responsibility of the vendor: 1. Inspect shipment for damages and shortages. 2. Supply a forklift to be on site at time of delivery, if needed. 3. Unload equipment from transport. 4. Uncrate and unpack equipment. 5. Set and anchor equipment. 6. Supervise plumbing and electrical hook-ups. 7. Weld components, where required. 8. Attach Umbilical cables to mounting brackets. 9. Mount instruction signs. 10. Mount wash selection and code entry box to contractor-supplied concrete pad. 11. Run all fluid hoses between pump modules and bay equipment. 12. Interconnect hoses between various spot-free rinse components 13. Program supplied components and train appropriate personnel in their operation and programming. 14. Interconnect hoses for cold water options. 15. Clean up of equipment. 16. Start-up, adjusts and test car wash equipment provided. 17. Inspect completed installation. 18. Train operator on use and basic maintenance.

Division 03 -	Concrete, Cast-in-Place Concrete, Concrete Finishing.
Division 07 -	Thermal and Moisture Protection, Dampproofing and Waterproofing.
Division 08 -	Openings, Metal Doors and Frames, Panel Doors.
Division 09 -	Finishes, Painting.
Division 10 -	Specialties, Signage.
Division 11 -	Equipment, Vehicle Service Equipment, Vehicle-Washing Equipment.
Division 22 -	Plumbing, Facility Water Distribution, Facility Storm Drainage.
Division 26 -	Electrical, Instrumentation and Control for Electrical Systems, Lighting, Interior Lighting, Exterior Lighting.
Division 31 -	Earthwork, Site Clearing, Grading.
Division 32 -	Exterior Improvements, Bases, Ballasts, and Paving, Rigid Paving, Concrete Paving, Curbs, Gutters, Sidewalks, and Driveways, Screening Devices, Planting Irrigation, Planting.
Division 33 -	Utilities, Water Utilities, Water Utility Distribution Piping, Sanitary Sewerage Utilities, Storm Drainage Utilities.
Division 44 -	Pollution and Waste Control Equipment.