Similar Projects
| Last Updated | 10/31/2019 04:20 PM |
| Project Title | Emergency Generator Maintenance and Repair Services |
| Physical Address | View project details and contacts |
| City, State (County) | State-Wide: OH |
| Category(s) | Single Trades |
| Sub-Category(s) | Electric |
| Contracting Method | Competitive Bids. |
| Project Status | Results |
| Bids Due | View project details and contacts |
| Estimated Value | $43,228 |
| Plans Available from | |
| Owner | View project details and contacts |
| Architect | View project details and contacts |
| Description | A. Engine and Mounting 1. Verify and record oil pressure and water temperature. 2. Test all safety shutdown circuits and alarms (over speed, over crank, low oil pressure, high water temperature low coolant level). 3. Inspect air intake system (air filter, crankcase breather, and turbocharger). 4. Inspect muffler system and drain condensation trap; verify rain cap operation. 5. Inspect engine starting system; verify cable integrity and connections. 6. Inspect exhaust flex coupling and piping for leaks and proper connection. 7. Check for abnormal vibration or noise. 8. Inspect spark plugs, plug wires and distributor. 9. Check ignition system. 10. Check and clean injector pump and injector flow rate, pressure and spray pattern. 11. Check valve clearance. 12. Check bolt torque. B. Fuel System 1. Inspect all fuel lines and hoses for leaks and general condition. 2. Inspect day tank and float assembly for proper operation and leaks. 3. Inspect fuel pump for leaks. 4. Verify proper operation of governor and governor linkage. 5. Check fuel level in primary supply tank. 6. Drain water and sediment from fuel filter and fuel supply tanks. 7. Adjust engine idle speed setting and electric governing system; check for proper governor operation. 8. Change fuel filter element and drain out sediment. 9. Check hydraulic governor oil level; change if necessary. C. Coolant System 1. Inspect all clamps, verify condition of all hoses and identify any leaks. 2. Verify proper operation of engine water jacket heater. 3. Test coolant freeze point and verify coolant level. 4. Test coolant additive package for proper corrosion inhibitors | ||
| Details |
|
||
| Bidder's List | View project details and contacts | ||
| Prospective Bidders | View project details and contacts | ||
| Project Documents |
 Engineered Spec Sheet  Architectural Plans  Other Documents |
