Cape Cod Canal - Inspect and Rehabilitate Bridge Bearings (Bourne and Sagamore Bridges)

Construction work for this project shall consist of the removal of debris, grease, and deteriorated concrete that has accumulated on the bearing seat and in between bearings on the piers for both the Bourne and Sagamore Bridges. The Contractor shall also be required to conduct ultrasonic testing of all bearing pins, repaint the entire bearing system from one foot above the top of each bearing's respective pin down to the bridge seat, lubricate all roller and rocker bearings, replace corroded existing bearing side plates and their associated fasteners with galvanized elements, and reattach the anchor bolt covering boxes to the bearings with waterproofing sealer. In addition to debris removal on the bearing seat and between piers, the Contractor shall be required to remove concrete debris and grease that has accumulated on the Sagamore's south abutment bridge seat.

Bridge, Renovation.

Division 01 -	General Requirements, Vehicular Access and Parking, Traffic Control, Temporary Barriers and Enclosures.
Division 03 -	Concrete, Concrete Reinforcing, Precast Structural Concrete.
Division 05 -	Metals, Structural Steel Framing, Structural Steel for Bridges, Steel Joist Framing, Steel Joist Girder Framing.
Division 07 -	Thermal and Moisture Protection, Expansion Control.
Division 09 -	Finishes, High-Performance Coatings.
Division 10 -	Specialties, Signage, Traffic Signage.
Division 26 -	Electrical, Exterior Lighting, Lighting Poles and Standards, Roadway Lighting.
Division 31 -	Earthwork, Embankments, Erosion and Sedimentation Controls, Slope Protection, Gabions, Riprap, Special Foundations and Load-Bearing Elements, Driven Piles.
Division 32 -	Exterior Improvements, Bases, Ballasts, and Paving, Flexible Paving, Rigid Paving, Fences and Gates, Retaining Walls.
Division 34 -	Transportation, Bridges.