Replace Electric Transformers/Various

Scope of Work The work to be performed under this project is located at Patrick Air Force Base. Patrick Air Force Base is located approximately three miles south of Cocoa Beach on State Road A1A. The work to consists of providing the labor, equipment and materials to replace open-wire pole-mount type transformers, and live-front transformer with new pad mounted transformers, high-voltage cables from switches to transformers, low-voltage cables from transformers to main panels, install new facility main distribution panels, and demolish stand-alone electrical vaults. Civil/Site. Provide trenching for new underground feeders per the drawings. Provide sodding of all newly graded finished earth surfaces, unless indicated otherwise, and at all areas inside or outside the limits of construction that are disturbed by the Contractor's operations. Water areas sodded daily. Apply water at a rate sufficient to ensure thorough wetting of soil to minimum depth of 6 inches for 14 continuous days after placement. Architectural. Demolish stand-alone electrical vaults, buildings 905, and 972. Core drill through walls, as shown in the drawings, to facilitate the installation of new electrical feeders. Provide new concrete pads for new electrical equipment per the drawings. Electrical Facility 720: Provide pad-mounted transformer to serve new main panel in existing facility 720, new main panel to serve branch feeders in existing main panel, existing main panel to be removed. Existing live-front transformers in facility 720 vault to be removed. Facility 546: Provide pad-mounted transformer to serve existing main panel in facility 546, provide new service disconnect and new service feeder to the extent indicated in drawings. Existing live-front transformers in facility 546 vault to be removed. Facility 806: Replace existing live-front pad-mounted transformer with new dead-front pad-mounted transformer, replace existing primary cable with new. Reconnect existing secondary service conductors to new transformer. Facility 945: Provide pad-mounted transformer to serve new main panel and new subpanel to be located in existing facility 945 chiller room. Panels to replace existing, new main panel to serve existing branch feeders and new subpanel, new subpanel to feed existing branch circuits. Existing live-front transformers in facility 945 vault to be removed. Install new light fixture in vault. Facility 985: Provide pad-mounted transformer to serve existing service mains for facility 985 and facility 988. Provide new service feeders and service disconnects as indicated in drawing. Existing live-front transformers in facility 985 vault to be removed. Install new meter to monitor facility 988. Facility 986: Provide pad-mounted transformer to serve two existing service mains for facility 986. Provide new service feeders and service disconnects as indicated in drawing. Existing live-front transformers in facility 986 vault to be removed. Facility 905: Provide pad-mounted transformer to serve existing lift station ATS (located in existing generator building) and existing parking area light fixtures. Provide new feeders to the extent indicated in drawings. Existing live-front transformers in facility 905 to be removed. Facilities 972, 996, and 997: Provide pad-mounted transformer to serve existing facilities 996 and 997, provide new feeders to the extent indicated in drawings. Existing live-front transformers in facility 972 to be removed. Provide temporary generator power during outages, as indicated in drawings.

Division 26 -

Electrical.