Video Security and Camera System

Replace the existing Bosch analog CCTV system with a new Bosch BVMS IP based system. Existing CCTV monitors will be replaced with a single 55 IN Bosch CCTV Monitor. New monitor to mount on existing pole. Existing camera call up monitor to remain and be reused for camera call ups Provide PC for camera call ups in Main Control The existing 79 analog cameras will be encoded into Bosch Encoders. The encoders will be in 4 locations. 7 cameras in room U228, 6 cameras in room V228, 22 cameras in room X228, 44 cameras in room I118. Install managed POE network switches in the above rooms with a core switch at the head end. Add connectors to 2 strands of existing fiber optic cable at each of the locations. Provide fiber optic modules for the network switches. 17 IP ready cameras will have baluns removed and RJ45 connectors installed, IP address programmed into cameras, then connected to new POE network switches, 9 cameras in X228 and 8 cameras in I118. Provide adequate storage for 140 cameras recording at 15FPS with a minimum of 60 days of retention. Two BVMS viewing workstations will be provided, configured and installed at owner specified locations. The camera call-ups will be rewritten in Indusoft to communicate with the new Bosch BVMS system. Reuse existing network rack for the new Bosch CCTV equipment.

Division 27 -	Communications, Common Work Results for Communications.
Division 28 -	Electronic Safety and Security, Common Work Results for Electronic Safety and Security.