Fulton Hall Boiler Replacement

Fulton Hall Boiler Replacement: Businesses with 7 + years' experience that can provide mechanical services to remove two (2) existing hot water heating boilers and replace with four (4) new boilers: - Boiler Removal - Disassemble, remove, and dispose of Boiler # 1 and Boiler #2. - Temporary Piping - A temporary 6” piping exists as part of the boiler rental configuration. This piping is to remain in place as a back-up until the new boilers are installed. Once the existing boilers are removed and the new boilers are installed, the temporary piping, hangers, and associated cabling is to be disconnected and removed. - Boiler Replacement - Coordinate the footprint of the new boilers and associated access requirements with the existing pads and extend the (2) 6” boiler pads as required. Provide and install a fully functional primary hot water plant including (4) natural gas fired high mass, high mass nominal 6,000 MBH fire tube high efficiency condensing boilers. - Other - Provide a full warranty for the new boiler system for parts and labor for two (2) years. The contractor shall have an approved boiler manufacturer repair service provider located within a 50-mile radius of the USMMA campus capable of responding to service calls. - Provide five (5) 8-hour days of training for USMMA personnel by October 1, 2022 in preparation for the fall heating season.

Division 23 -

Heating, Ventilating, and Air Conditioning (HVAC), Instrumentation and Control for HVAC, HVAC Air Distribution, Heating Boilers, Central HVAC Equipment.