Rockwood Fire Station Expansion

1. Remove trees to the left side of the station in the building area 2. Prepare the ground for the slab 3. Put in a 6” (inch) slab pinned to the existing with a raised haunch to match the existing building 4. Run radiant heat lines in the slab and tie into the existing system 5. Pour floor with 400PSI mix and re-bar 6. Frame walls with 2 x 6 construction 7. Remove shingles on the South (left) side of roof and redo with addition to match north (right) side 8. Sheath for ice and water and shingle 9. Install metal siding to match existing siding 10.Install new overhead door to match existing doors 11.Cut a new entrance doorway in the new addition. Take out a window and cut cement to the floor. Remove rear door for a second access point 12.Install new rear entrance door in back of the new addition 13.Install all new electrical lines to include outlets, LED ceiling lights and tie into the existing electrical panel 14.Insulate the structure to meet code 15.Apply interior sheathing on walls and ceiling that is moisture resistant and waterproof panels from the haunch up 6 feet 16.Cut out rear of what will be the middle bay once the addition has been added and put in a new garage door that matches the from door that will be 12 ft. wide x 12 ft. high 17.Remove all debris, clean the site when the project is done

Division 03 -	Concrete, Concrete Forming and Accessories, Cast-in-Place Concrete.
Division 04 -	Masonry, Unit Masonry.
Division 06 -	Wood, Plastics, and Composites, Rough Carpentry, Finish Carpentry.
Division 07 -	Thermal and Moisture Protection, Dampproofing and Waterproofing, Thermal Protection.
Division 08 -	Openings, Doors and Frames, Windows.
Division 09 -	Finishes, Plaster and Gypsum Board, Ceilings, Flooring, Painting and Coating.
Division 10 -	Specialties, Signage.
Division 22 -	Plumbing.
Division 23 -	Heating, Ventilating, and Air Conditioning (HVAC).
Division 26 -	Electrical.
Division 27 -	Communications.
Division 32 -	Exterior Improvements.