Red River Remove, Cap and Drill Two New Water Well

Services required: 1) Excavate, disassemble, remove and cap off the existing two wells and casing 2) Drill, construct, and install two new wells. Well #1 consist of the following specs: One 10’ X 6” 20HP (three phase) Submersible Well (1,000 GPM range) with a 6” Check valves and 480 Volt Panel. Well #2 consists of the follow specs: One 12 X 6” line shaft turbine well (1,000 GPM Range) with a 6” check valve for discharge 3) One new gear head with minimum specs as follows: 40HP Gear drive 1-1 Ratio with 41x36 Driveshaft. 4) 2,200 feet of 10” 80 PSI Underground pipe (installed); five 10” Risers Complete; one 10” 90 PVC elbow PIP GxS; three 10” Line Tees GxSxG; three 10” PIP End Plugs 80 PSI PVC; two 16” steel surge Tanks (installed beside wells) **Contractor will supply all materials, equipment, and labor**

Division 02 -	Existing Conditions, Subsurface Investigation.
Division 03 -	Concrete, Cast-in-Place Concrete.
Division 22 -	Plumbing, Plumbing Piping, Plumbing Equipment.
Division 26 -	Electrical, Instrumentation and Control for Electrical Systems.
Division 33 -	Utilities, Water Utilities, Water Utility Distribution Piping, Water Utility Distribution Equipment, Water Utility Pumping Stations, Wells.
Division 44 -	Pollution and Waste Control Equipment, Water Pollution Control Equipment.