Api 653 Tank Inspection - Shaw Afb

Remove and transfer approximately 150 gallons of fuel/sludge. Any fuel or residual product that will be disposed of the contractor will be responsible to coordinate with environmental and safety authorities having jurisdiction to obtain and execute required permits, manifests, etc. Clean the tank and perform an internal AST inspection to also include the visual inspection of the containment area. Tank cleaning shall be done in accordance with UFGS 33 01 50.60. The tank Inspection shall be in conformance with applicable industry standards API 653, NFPA 30, NFPA 326, UFGS 33 01 50.60, and in compliance with 40 CFR 112, UFC 3-460-01, UFC 3-460-03 and any other applicable federal, state, local, service or host nation requirements. At a minimum, table 8-1 within UFC 3-460-01 shall be followed. All tank appurtenances that are required shall be documented along with all required appurtenances that aren’t present. Alarms, Automatic Tank Gauge equipment, and all tank appurtenances shall be tested and verified. The attached Inspection Report template should be utilized in submitting both the DRAFT and FINAL inspection reports. Contractor shall leave a clean and orderly site upon the completion of the inspection.

Division 02 -	Existing Conditions, Subsurface Investigation.
Division 03 -	Concrete, Concrete Reinforcing, Cast-in-Place Concrete.
Division 05 -	Metals, Structural Metal Framing, Metal Decking.
Division 23 -	Heating, Ventilating, and Air Conditioning (HVAC), Facility Fuel Piping, Facility Fuel-Storage Tanks.
Division 31 -	Earthwork, Clearing and Grubbing, Grading.
Division 32 -	Exterior Improvements, Fences and Gates.
Division 33 -	Utilities, Storm Drainage Utilities.