Reno County Solid Waste - Cell 8 Construction

11-389T The scope of work for this project generally consists of earthwork and composite landfill liner installation for a municipal solid waste landfill cell with an approximate 7-acre disposal area (approx. 10-acre total disturbance area). Earthwork primarily consists of excavating and/or placing compacted fill to achieve subgrade elevations. Construction of the Cell 8 landfill liner system includes the following layers from bottom to top: subgrade, 1-foot thick low permeability soil liner, geosynthetic clay liner, smooth and textured 60-mil high density polyethylene liner, and 18-inch thick sand protection/drainage layer. The project also includes installing perforated leachate collection piping within granular drainage material enveloped in a non-woven geotextile, solid leachate cleanout piping with a reinforced-concrete headwall at the terminus, installation of a dual-walled temporary sump, piping, electrical, and re-vegetating areas disturbed by construction activities. Prospective Bidders are urged to register with the designated portal as a plan holder, even if Bidding Documents are obtained from the Issuing Office or source other than the designated website in either electronic or paper format. The designated website will be updated periodically with addenda, lists of registered plan holders, reports, and other information relevant to submitting a Bid for the Project. All official notifications, addenda, and other Bidding Documents will be offered only through the designated portal. Neither Owner nor Engineer will be responsible for Bidding Documents, including addenda, if any, obtained from sources other than the designated portal. Questions will be accepted up to August 12, 2022 at 5:00 CDT. Questions submitted after this time will not be addressed. Please direct any questions regarding this Invitation to Bid to slinehan@scsengineers.com. Instructions to Bidders: For all further requirements regarding bid submittal, qualifications, procedures, and contract award, refer to the Instructions to Bidders that are included in the Bidding Documents.

Division 03 -	Concrete, Concrete Forming and Accessories, Cast-in-Place Concrete.
Division 04 -	Masonry, Unit Masonry.
Division 06 -	Wood, Plastics, and Composites, Rough Carpentry, Finish Carpentry, Millwork.
Division 07 -	Thermal and Moisture Protection, Dampproofing and Waterproofing, Thermal Protection, Weather Barriers.
Division 08 -	Openings, Doors and Frames, Entrances, Windows.
Division 09 -	Finishes, Plaster and Gypsum Board, Acoustical Ceilings, Flooring, Carpeting, Acoustic Treatment, Painting.
Division 12 -	Furnishings.
Division 21 -	Fire Suppression, Water-Based Fire-Suppression Systems, Fire-Extinguishing Systems.
Division 22 -	Plumbing, Instrumentation and Control for Plumbing, Plumbing Piping, Plumbing Equipment, Plumbing Fixtures, Drinking Fountains and Water Coolers.
Division 23 -	Heating, Ventilating, and Air Conditioning (HVAC), Instrumentation and Control for HVAC, HVAC Air Distribution, Central HVAC Equipment.
Division 26 -	Electrical, Power Distribution Units, Lighting, Interior Lighting, Emergency Lighting, Exit Signs, Exterior Lighting.
Division 27 -	Communications, Structured Cabling, Data Communications, Voice Communications.
Division 28 -	Electronic Safety and Security.
Division 31 -	Earthwork, Clearing and Grubbing, Grading, Soil Treatment.
Division 32 -	Exterior Improvements, Flexible Paving, Asphalt Paving, Rigid Paving, Concrete Paving, Curbs, Gutters, Sidewalks, and Driveways, Paving Specialties, Parking Bumpers, Pavement Markings, Fences and Gates, Irrigation, Planting.
Division 33 -	Utilities.