(SATOC) (IDC M-807) for General Architect Engineering Services and Sustainment, Renovation and Modernization (SRM)

A-E services may include but not be limited to the following: preparation of studies, concept and final designs leading to Sustainment, Renovation and Modernization (SRM) construction projects; planning charrettes; professional engineering services; pre-design site assessment; feasibility and concept studies; geotechnical investigation and reports; environmental investigations including permitting studies and reports; asbestos and lead sampling and abatement; site development; cost engineering using MII CACES; value engineering; life cycle costing; post-design shop drawing review; construction phase services; and construction administration. Additional services include but are not limited to: seismic design; topographic and boundaries surveys to include mapping and analysis (including data collection and verification); historical and cultural resources investigations; design review; seismic analysis; environmental analysis; site surveys and evaluation; remediation design; and Environmental Protection Agency (EPA) compliance for Hazardous materials such as petroleum products, asbestos, lead and radon. In Addition New Jersey Department of Environmental Protection (NJDEP), flood hazard analysis/permitting; parametric design; and wetlands remediation and mitigation. The contractor is also required to have expertise and knowledge of the design of Anti-Terrorism/Force Protection (AT/FP) requirements, security and communications systems, fire protection and life safety systems, CADD/GIS, Building Information Modeling (BIM), Sustainable design, Leed Green Building, and preparation of Department Of Defense Explosive Safety Board Submissions, explosive safety design and development of explosive safety Arcs. Examples of potential work include design of New Buildings and Facilities, including but not limited to the following: Research and Development Facilities for advanced weapons systems (these facilities will require blast protection and explosive safety design); Laboratories, Ordinance Handling and Storage Facilities, Magazines and Ammunitions Storage, Vehicle Maintenance Facilities, Administrative Buildings, Industrial Facilities, Indoor and Outdoor Test Ranges, Infrastructure Systems and Laboratories. Design of repair and/or renovation projects to include the following: Whole Building Renovation, Research and Development Facilities for advance weapons systems ( these facilities will require blast protection and explosive safety design), Laboratories, Replacement of Architectural Elements, Building Seismic Upgrade; Force Protection Upgrades, Mechanical, Electrical, Fire Protection/Detection Systems, Asbestos and Lead Abatement Services or Demolition. Preparation of environmental regulatory documents and permit applications. Engineering inspections/assessments of existing and under construction vertical/horizontal structures. Projects designed under these contracts may require designers to obtain security clearances as well as having physical security measures in place before a firm can do the work. Security clearances are not required at the time of selection or award of a contract.