Clearwell Repairs at Well 1

This contract generally consists of removing the clearwell coating from both clearwells at Well No. 1 and performing repairs as necessary, including all relevant disinfection and sampling of the clearwells and associated pumps.The Contract Documents, consisting of Advertisement for Bids, Instructions to Bidders, Bidder's Checklist, Bid, Bid Bond, Agreement, General Conditions, Supplementary Conditions, Payment Bond, Performance Bond, Maintenance Bond, Specifications, Figures and Addenda may be examined at the following location: D&B Engineers and Architects, D.P.C. 330 Crossways Park Drive Woodbury, NY 11797-2015 (516) 364-9890 Each Bid must be accompanied by a certified or bank cashier's check made payable to OWNER, or a Bid Bond issued by a surety licensed to conduct business in the state where the Project is located and having a Best Rating of A- or better from A.M. Best Company and named in the current list of "Companies Holding Certificates of Authority as Sureties on Federal Bonds and as Acceptable Reinsuring Companies" as published in Circular 570 (amended) by the Financial Management Service, Surety Bond Branch, U.S. Department of the Treasury, in an amount not less than five percent of the amount of the Bid submitted. The list may be ordered from the Government Printing Office Bookstore, 26 Federal Plaza, Room 110, New York, NY 10278, (212) 264-3825. The Bidder to whom the OWNER proposes to award the Contract will be required to furnish performance and payment bonds and the necessary insurance certificates as prescribed in the General Conditions and the Supplementary Conditions within ten (10) days of the Notice of Award. Each Bidder must complete and submit with his/her bid the "Iranian Investment Activities Certification" provided in the Bid Form in compliance with General Municipal Law 103-g, Iranian Energy Sector Divestment. Each Bidder must complete and submit with his/her Bid the "Certification of Compliance with New York State Labor Law Section Two Hundred One-G" provided in the Bid Form regarding the implementation of a written policy addressing sexual harassment prevention in the workplace. Bidders are required to execute a non-collusive bidding certification required by Section 103-d of the General Municipal Law of the State of New York The attention of Bidders is particularly called to the requirements as to the conditions of employment to be observed and the minimum wage rates to be paid under the contracts. Bidders are also required to comply with the anti-discrimination provisions of Sections 290-301 of the Executive Law of the State of New York. The OWNER reserves the right to reject any or all of the Bids received, to readvertise for Bids, to abandon the project, to waive any or all informalities in any Bid received and to accept any proposal which the OWNER decides to be for the best interest of the OWNER. Note: All questions must be submitted, in writing, to Peter Connell, no later than 4:00 p.m. on Friday, July 22, 2022. Questions must be sent via email to pconnell@db-eng.com.

Division 03 -	Concrete.
Division 04 -	Masonry.
Division 05 -	Metals.
Division 06 -	Wood, Plastics, and Composites.
Division 07 -	Thermal and Moisture Protection.
Division 08 -	Openings.
Division 09 -	Finishes.
Division 10 -	Specialties, Signage, Toilet, Bath, and Laundry Accessories, Fire Protection Specialties, Fire Extinguishers, Storage Specialties.
Division 11 -	Equipment.
Division 12 -	Furnishings.
Division 14 -	Conveying Equipment, Scaffolding.
Division 21 -	Fire Suppression.
Division 22 -	Plumbing.
Division 23 -	Heating, Ventilating, and Air Conditioning (HVAC).
Division 26 -	Electrical.
Division 27 -	Communications, Data Communications, Voice Communications, Audio-Video Systems.
Division 28 -	Electronic Safety and Security.
Division 31 -	Earthwork.
Division 32 -	Exterior Improvements, Fences and Gates, Turf and Grasses.
Division 33 -	Utilities, Common Work Results for Utilities, Water Utility Distribution Equipment, Water Utility Pumping Stations, Wastewater Utility Pumping Stations, Sanitary Utility Sewerage Force Mains.
Division 40 -	Process Integration, Water Process Piping.
Division 45 -	Industry-Specific Manufacturing Equipment.
Division 46 -	Water and Wastewater Equipment.