Install Electric Circuit

1. Install new 1-1/2” EMT conduit and wire from existing panel inside of building to a new 100A disconnect. The new 1-1/2” EMT conduit will be ran above the acoustical ceiling. (See sheet E2). Install new 3 pole breaker in existing panel inside B3185. 2. Dig new trench from new 100A disconnect to the point of connection on the new building. Trench is approximately 52 feet long. (See Sheet E3). 3. Install new 1-1/2” PVC SCH 40 conduit underground from new 100A disconnect to existing electrical panel on structure. (See sheet E3). 4. Tie into existing communications in area shown on drawings. Run new 2” EMT to new 12x12x6 J-Box. Run 2” EMT from J-Box to grade and run 2” PVC SCH 40 w/ mule tape underground to communications box on structure as shown on drawings. 5. Pull 4-#2 and 1-#8 AWG THHN copper wires from existing panel to new 100A disconnect and from 100A disconnect to existing electrical panel on structure. Communications wire to be installed by others. 6. Install grounding rods at the location specified on sheet E3. Customer will provide 8’ grounding rods, wire, and accessories for the install. 7. Energize and test all components to ensure safety and full satisfaction of all requirements.

Division 26 -

Electrical.