Fuel Pump Boot Dispenser Replacement

8(a) Set-Aside. The contractor shall perform the following tasks for replacing fuel dispenser penetration boots at facility 2446 at DMAFB. 1. Place barricades / fencing to secure 2 dispensers. Work will be phased and limited to 2 dispensers at a time. This will ensure a minimum of 4 dispensers (8 hoses) always available for customers. 2. Remove existing fuel dispensers from secured island. 3. Replace all penetration boots for the under-dispenser containment (UDC) pans and underground storage tanks (UST) sumps. 4. After replacement of penetration boots, contractor shall reinstall the existing fuel dispensers. 5. Perform hydrostatic tests on each UDC pan, UST sump, and all fuel lines. 6. After successful hydrostatic test, contractor shall re-start up the fuel dispensers. 7. Relocate barricades / fencing to secure the next 2 dispensers. Repeat steps 2-6. 8. Relocate barricades / fencing to secure the final 2 dispensers. Repeat steps 2-6.

Division 02 -	Existing Conditions, Subsurface Investigation.
Division 03 -	Concrete, Cast-in-Place Concrete.
Division 22 -	Plumbing, Plumbing Piping, Plumbing Equipment.
Division 26 -	Electrical, Instrumentation and Control for Electrical Systems.
Division 33 -	Utilities, Water Utilities, Water Utility Distribution Piping, Water Utility Distribution Equipment, Water Utility Pumping Stations, Wells.
Division 44 -	Pollution and Waste Control Equipment, Water Pollution Control Equipment.