Similar Projects
Fence at Centennial Farm
Bidding
Grosse Ile, MI 48138

Fencing Replacement and Installation DW-TSD
Term Contract
Bidding
Troy, MI

Collett Site Maintenance
Post-Bid
Brighton, MI

Baseball/Softball Fencing
Post-Bid
Three Oaks, MI

Temporary Bus Parking Lots - Fencing
Results
Less than $42,450 est. value
Rochester, MI

Sliding Security Gate and Controls Replacement, East and West Administration Buildings Chippewa Correctional Facility
Results
Kincheloe, MI

M-68 Trout Club Fence Project
Infrastructure
Bidding
MI

DNR LED Trailers
Post-Bid
Marquette, MI

Maplewood Center and Manor Park Fencing
Results
Less than $37,452 est. value
Garden City, MI

Bus Garage Fencing
Post-Bid
Madison Heights, MI

Dearborn Shutoff Gates and Overflow Structure
Results
Dearborn, MI

Fence Installation, Replacement, and Repair Services
Post-Bid
Clinton Township, MI 48038

Perimeter Fencing
Results
Livonia, MI 48154

Fencing for DPSCD Schools
Post-Bid
Detroit, MI

Cemetery Fencing
Results
Less than $45,668 est. value
Portage, MI 49002

Reported 05/19/2021 12:00 AM
Project Title

Poe Gate 1 Blasting & Coating

Physical Address View project details and contacts
City, State (County) Sault Sainte Marie, MI 49783   (Chippewa County)
Category(s) Single Trades
Sub-Category(s) Fencing
Contracting Method Competitive Bids.
Project Status Request for Proposals (RFPs)
Bids Due View project details and contacts
Estimated Value $1,000,000 to $5,000,000
Plans Available from Federal Agency
Owner View project details and contacts
Architect View project details and contacts
Description

The general scope of the project is the surface repair and coating of one miter gate leaf, approximately 63 feet wide by 35 feet tall. The gate will remain in place and would require a wind resistant, enclosed, climate controlled environment with a minimum temperature of 45 degrees Fahrenheit to be constructed around it. Cracked, pitted, or damaged gate surfaces that are discovered after initial surface preparation activities shall be adequately repaired. It is critical that the final surface preparation meets “white metal” in accordance with SSPC SP 5 criteria and that stringent full time technically qualified quality control is maintained during surface preparation and coating application. The coating is an USACE exclusive marine grade vinyl based coating that shall be applied immediately after welding repairs to stiffener plates, fender mounting brackets and final surface preparation activities. Some disassembly and reassembly of existing/new replacement gate components will be required, including grease lines, electrical conductors, signal lights, walkway platform, hand rail, flushing valves, timber fenders, structural stressing diagonals, gate seals, and access hatch. The Contractor will be required to furnish new gate seals, timber fenders and diagonals. Adequate lead time will be required to furnish these specialty items. New diagonals are currently being designed and the contractor will need to furnish and install. Design of new diagonals will differ from existing and install time will need to account for gate repair and coating activities. Work shall not exceed one season of winter closure activities. Protection of the gate anchorages, quoin blocks, miter blocks, hydraulic cylinder and connection, and pintles will be required throughout the project. Compressed air, natural gas, and electric will be provided by the Government if necessary.

Details

Division 01 - General Requirements, Quality Control, Testing and Inspecting Services.
Division 26 - Electrical.
Division 32 - Exterior Improvements, Fences and Gates.

Bidder's List View project details and contacts
Prospective Bidders View project details and contacts
Project Documents
 Engineered Spec Sheet
 Architectural Plans
 Other Documents