Critical Repair Program - 1218 Satchell Street - Roof Replacement

For roof materials, application, installation, etc. and Section 309 for roof and ceiling framing, and all other codes that govern. A building permit is required if there is any wood to be replaced. Pictures must be provided, through each step, to housing inspector during repair. Pictures must be clear, and referenced to home being worked on. Pictures are to be provided in real time, prior to home being completed. Areas that are found to be spaced decked shall be covered with 16" exterior grade sheathing material after removing the existing decking. It is the contractors responsibility to ensure the framing and structure will support the additional load. Remove existing roofing materials down to bare decking. Check all rooftrusses/rafters and repair/replace as needed to ensure that new roofstructure is flat and smooth without rises or depressions in roofsystem. Replace all rotten, broken, un-even, weak, or deteriorated decking framing, fascia and etc. Any exposed repaired or replace wood should be protected from the elements, painted to match existing color or white. Replaced/repaired decking shall be level and ready to accept felt and shingles. Check all rooftrusses for strength and stability before re-shingling house. Remove all unused elements, vents, etc., that are not operational and close them below roof level. Re-flash all valleys, vents, roof openings, and chimneys. Install new boots around all roof penetrations. Haul away debris immediately. Use a magnetic sweep around the perimeter of house and rake away any other debris. Cover entire roof decking with self-adhered roofing underlayment then install 15 asphalt impregnated felt underlayment. Prepare roof decking to accept a ridge vent. Re-roof with a 30year dimensional class A fiberglass asphalt shingle.

Division 07 -

Thermal and Moisture Protection, Dampproofing and Waterproofing, Thermal Protection.