Similar Projects
Last Updated | 06/15/2021 09:23 AM |
Project Title | SP-Gasoline Powered Centrifugal Pump |
Physical Address | View project details and contacts |
City, State (County) | Downers Grove, IL (DuPage County) |
Category(s) | Sewer and Water |
Sub-Category(s) | Pumps and Wells |
Contracting Method | Competitive Bids. |
Project Status | Request for Quotations |
Bids Due | View project details and contacts |
Estimated Value | |
Plans Available from | State Agency |
Owner | View project details and contacts |
Architect | View project details and contacts |
Description | 1. Sixteen horsepower minimum overhead valve engine with recoil start and low oil shutdown. 2. Nine-quart fuel tank. 3. Self-priming to twenty feet lift minimum centrifugal pump. 4. 630 gallons per minute at ten feet of head minimum. Maximum head to be 120 feet. 5. Pump to be capable of pumping liquid with up to two-inch diameter solids. 6. Pump must be capable of being cleaned out without disconnecting hoses. 7. Pump body to be aluminum with cast iron impeller. 8. Replaceable wear plate and seal. 9. Pump shall be equipped with two, four-inch pipe nipples, one on intake and one discharge. 10. The unit shall be equipped with pneumatic wheels with ball bearings and brake feet. 11. The unit shall include four-inch NPT inside diameter PVC water suction hose 20 feet in length. 12. The suction hose shall come equipped with swivels which shall be four-inch NPT aluminum male and four-inch NPT brass female. 13. The bend radius of the suction hose shall be sixteen inch and reinforced to prevent collapsing with vacuum of twenty-nine inch mercury (“Hg”). 14. The suction hose shall be rated for the pump. 15. The unit shall come with a zinc plated steel suction strainer four-inch NPT and seven inch in diameter five inch in height with 1 ½” x 1 ½” square openings. 16. The unit shall be equipped with a pressure hose four inch in diameter and fifty feet in length. 17. The pressure hose shall come equipped with swivels on each end which shall be four inch NPT aluminum male and four inch NPT brass female. 18. The pressure hose shall be PVC with fiber reinforcement matched to the output of the pump. 19. The unit shall come with a 12 ½” pin lug spanner wrench for the hoses. |
||||||||||||
Details |
|
||||||||||||
Bidder's List | View project details and contacts | ||||||||||||
Prospective Bidders | View project details and contacts | ||||||||||||
Project Documents |
Engineered Spec Sheet Architectural Plans Other Documents |