Stunner Bridge Repair

8(a) Set-Aside. Scope of Work: The work shall consist of what is shown on the plans, stated in the specifications, and summarized below: Establish the traffic control signing as required Install the bridge rails Remove trees and clear and grub as required Obliterate the old road and use the material to complete the new embankments Excavate for footings Install asphalt paving Construct the footings Install the approach rails Construct the abutments and wingwalls Open the road new road to traffic Backfill the abutments Close the road to existing bridge Grade portions of the channel banks under the new bridge Remove the existing bridge Install riprap adjacent to the new structure Complete the grading at the location of the original bridge and road Erect the steel girders Complete the riprap installation along the stream Place concrete deck Prepare the finished grading and apply seeding Construct the remaining backfill and a portion of the approach embankments

Bridge, Renovation.

Division 01 -	General Requirements, Vehicular Access and Parking, Traffic Control, Temporary Barriers and Enclosures.
Division 03 -	Concrete, Concrete Reinforcing, Precast Structural Concrete.
Division 05 -	Metals, Structural Steel Framing, Structural Steel for Bridges, Steel Joist Framing, Steel Joist Girder Framing.
Division 07 -	Thermal and Moisture Protection, Expansion Control.
Division 09 -	Finishes, High-Performance Coatings.
Division 10 -	Specialties, Signage, Traffic Signage.
Division 26 -	Electrical, Exterior Lighting, Lighting Poles and Standards, Roadway Lighting.
Division 31 -	Earthwork, Embankments, Erosion and Sedimentation Controls, Slope Protection, Gabions, Riprap, Special Foundations and Load-Bearing Elements, Driven Piles.
Division 32 -	Exterior Improvements, Bases, Ballasts, and Paving, Flexible Paving, Rigid Paving, Fences and Gates, Retaining Walls.
Division 34 -	Transportation, Bridges.