Critical Repair Program - 7310 4th Street - Multiple Scope Bid Project

All work shall meet or exceed the requirements of the ICC Residential Code and the Standard Building Code (C) Section 1501 for roof materials, application, installation, etc. and Section 309 for roof and ceiling framing, and all other codes that govern. A building permit is required if there is any wood to be replaced. Pictures must be provided, through each step, to housing inspector during repair. Pictures must be clear, and referenced to home being worked on. Pictures are to be provided in real time, prior to home being completed. Areas that are found to be spaced decked shall be covered with A" exterior grade sheathing material afterremoving the existing decking. Itisthe contractors responsibility to ensure the framing and structure will support the additional load. Remove existing roofing materials down to bare decking. Check all rooftrusses/rafters and repair/replace as needed to ensure that new roofstructure is flat and smooth without rises or depressions in roof system. Replace all rotten, broken, un-even, weak, or deteriorated decking framing, fascia and etc. Any exposed repaired or replace wood should be protected from the elements, painted to match existing color or white. Replaced/repaired decking shall be level and ready to accept felt and shingles. Check all rooftrusses for strength and stability before re-shingling house. Remove all unused elements, vents, etc., that are not operational and close them below roof level. Re-flash all valleys, vents, roof openings, and chimneys. Install new boots around all roof penetrations. Haul away debris immediately. Use a magnetic sweep around the perimeter ofhouse and rake away any other debris. Cover entire roofdecking with self-adhered roofing underlayment then install 15# asphalt impregnated felt underlayment Prepare roof decking to accept a ridge vent. Re-roof with a 30year dimensional class A fiberglass asphalt shingle. (Owners choice of color) (ANY AREA DEEMED TO NEED ROLL ROOFING MATERIAL WILL BE SELF ADHERING MODIFIED BITUMEN) CAP SHEET AND (BASE SHEET IF NEEDED) INSTALL PROPER METAL DRIP RAIL FOR THIS STYLE ROOFING. o Shingles must be 1st quality still in the wrapper. Seconds will not be accepted. o Install drip rail around perimeter ofhouse. Shingles shall have 14" to 1 'A" overhang. o Install roof over ridge vent with-in 2ft of end of ridge (end to end) or wind turbines, (minimum oftwo) as appropriate. o New roof shall be structurally sound and leak free. o Contractorshall warrant the roof to be completely leak free for one year.

Division 07 -

Thermal and Moisture Protection, Dampproofing and Waterproofing, Thermal Protection.