Hoods Mill Well Drilling and Testing Services

Four six-inch diameter test wells, then reaming out and completing the best yielding well as an 8-inch diameter steel production well (herein referred to as production well). Any other test well will be completed as a 6-inch diameter PVC monitoring well (herein referred to as monitoring well), unless County personnel otherwise direct that a boring be abandoned. Thereafter, and following adequate well development, aquifer testing on the newly completed production well is planned, with water level monitoring of the 6-inch diameter PVC monitoring wells. At minimum, the proposed work will entail drilling up to four 6-inch diameter PVC test wells, converting one test well into an 8-inch diameter steel production well completed with cement grout, well development of the future production well and any permanent monitoring wells, one full day of step-drawdown testing services and a fully manned 96-hour constant rate aquifer test on the production well.

Division 02 -	Existing Conditions, Subsurface Investigation.
Division 03 -	Concrete, Cast-in-Place Concrete.
Division 22 -	Plumbing, Plumbing Piping, Plumbing Equipment.
Division 26 -	Electrical, Instrumentation and Control for Electrical Systems.
Division 33 -	Utilities, Water Utilities, Water Utility Distribution Piping, Water Utility Distribution Equipment, Water Utility Pumping Stations, Wells.
Division 44 -	Pollution and Waste Control Equipment, Water Pollution Control Equipment.