S208--FY20 802-M&R20-03| Baltimore NC | Request for required funds to facilitate the repair of chain link fence damage at 6 different sections of the perimeter totaling approximately 600 linear feet.

Statement of Work Summary: Contractor shall furnish all tools, labor, material, equipment and supervision necessary to repair damage at six (6) different sections of perimeter chain link fence (see map below) totaling approximately 600 l.f. Photographs do not fully show all repairs at each section but do show the most severe instances. Work shall include but not limited to removal of existing damaged fence and posts, removal of fallen trees, installation of new posts set in concrete and new 7 ft high chain link fence. General: Contractor is strongly encouraged to survey the project area prior to bidding to adequately understand the full scope of work and all requirements. An organized site visit will be scheduled and announced in the Request for Quote (RFQ). Contractor is required to submit any questions or clarifications prior to bid. A bid submitted will be taken as agreement that the work shall be performed to meet the requirements herein based on the existing conditions in the field. The contractor shall prepare submittals including shop drawings and any other specification requirements to the field COR and Project Engineer for review and approval prior to fabrication/installation. Submittals approved by the owner (VA/NCA) are required prior to starting on the corresponding work. For all invoice requests, the contractor shall submit a draft invoice/payment request concurrently to the field COR and the Project Engineer for dual approval. Only when the field COR and the Project Engineer approve of the draft invoice may it then be formally submitted for payment. All personnel will comply with all Dignity Clause requirements (ref. spec. para. 010002-1.6.P) Specific Work Items: Remove and properly dispose of damaged/down sections of chain link fence and associated hardware. Remove and clean up down trees, branches etc. as necessary to allow full restoration of perimeter fence (See Photographs 1-7). Set new fence posts in concrete footers 30 deep and 4 times the post diameter. New fence posts shall be set at 10 ft. centers. Install new 7 ft. tall chain link fence to replace demolished sections. Install new 10 ft wide gate at Sections G and H. At the completion of the project, the grounds around the worksite will be returned to pre-construction condition.

Division 32 -

Exterior Improvements, Fences and Gates.