District 3 Bridge Project

Contractor shall: • Drive 14 abutment piles to practical refusal, plan depth 40 feet. • Drive 12 wing piles to at least 10 feet below stream bed or to refusal plan depth 30 feet. • Set 2 caps at height determined by Custer County. • Weld in x braces per plan. • Drive and cut interlock sheeting at least 5 feet below stream bed or to refusal. • Install metal deck form, place and tie 2 layers of reinforcing steel. • Cap all sheeting. • Place guard rail on abutment and wings. • Pour and finish concrete. Project Location: Location N2070 and E960001.

Division 01 -	General Requirements, Vehicular Access and Parking, Traffic Control, Temporary Barriers and Enclosures.
Division 03 -	Concrete, Concrete Reinforcing, Precast Structural Concrete.
Division 05 -	Metals, Structural Steel Framing, Structural Steel for Bridges, Steel Joist Framing, Steel Joist Girder Framing.
Division 07 -	Thermal and Moisture Protection, Expansion Control.
Division 09 -	Finishes, High-Performance Coatings.
Division 10 -	Specialties, Signage, Traffic Signage.
Division 26 -	Electrical, Exterior Lighting, Lighting Poles and Standards, Roadway Lighting.
Division 31 -	Earthwork, Embankments, Erosion and Sedimentation Controls, Slope Protection, Gabions, Riprap, Special Foundations and Load-Bearing Elements, Driven Piles.
Division 32 -	Exterior Improvements, Bases, Ballasts, and Paving, Flexible Paving, Rigid Paving, Fences and Gates, Retaining Walls.
Division 34 -	Transportation, Bridges.