Construction Journal Try for free >
Similar Projects
Utility Monitoring and Control Systems
Post-Bid
Less than $2,100,000,000 est. value
Circuit Compressor Replacement on HVAC Chiller Unit
Post-Bid
Richmond, VA
Replace Kitchen Exhaust Hood System
Results
Chesterfield, VA
Fire Restoration Services - Creighton
Results
Richmond, VA
Preventative Maintenance Heating and Cooling Systems
Term Contract
Post-Bid
Richmond, VA
Baseboard Heaters Installation
Results
Richmond, VA
J--Cooling Towers Preventative Maintenance
Post-Bid
Richmond, VA 23249
JTCC-M Physical Plant Warehouse AC Upgrades
Results
Midlothian, VA
Rooftop Air Handling Unit Repair at Gordon Elementary School
Post-Bid
VA 23236
DVS Sitter and Barefoot Veterans Care Center - Chiller Temporary Connection
Results
Richmond, VA 23219
Rooftop Heat Pump Replacements
Post-Bid
Bon Air, Chester, Chesterfield, Richmond, VA 23237
HVAC Equipment Replacement Public Safety Training Facility and ECC Building
Results
Chesterfield, VA
Cooling Tower Replacements
Post-Bid
Chester, VA 23831
HVAC, Chiller Refurbish at Meadowbrook High School
Results
VA
Z--Replace HVAC System Project 652-17-102
Post-Bid
$1,000,000 to $2,000,000 est. value
Richmond, VA 23249

HVAC Construction Project Lead, Chester, VA 23831   (Chesterfield County)

Share
Last Updated 12/06/2018 11:36 AM
Project Title

Replacement of HVAC Equipment at Carver Middle School
Physical Address View project details and contacts
City, State (County) Chester, VA 23831   (Chesterfield County)
Category(s) Single Trades
Sub-Category(s) HVAC
Contracting Method Competitive Bids.
Project Status Results
Bids Due View project details and contacts
Estimated Value
Plans Available from County Agency
Owner View project details and contacts
Architect View project details and contacts
Description Replace existing 20-ton McQuay condenser unit and Evaporator at Carver Middle School 1. Lock and tag out electrical unit. 2. Include any permits if required. 3. Recover and store refrigerant from existing system., Refrigerant to be turned over to owner at project completion if owner so chooses to accept it, otherwise refrigerant to be removed from site at Contractor's expense. 4. Remove existing high and low voltage wiring. 5. Disconnect all refrigerant and plumbing lines. 6. All refrigerant piping to be fully evacuated and pressure tested. 7. Remove and legally dispose off site of existing unit. 8. Provide, deliver, and install new 20-ton condensing unit. Contractor to include crane or other necessary hoisting equipment. 9. Set new unit on existing curb. If unit does not fit on existing curb, contractor to provide new rubber mounted curb beside existing curb. 10. Replace condenser on the roof.
Details
Division 23 - Heating, Ventilating, and Air Conditioning (HVAC), Instrumentation and Control for HVAC, HVAC Air Distribution, Central HVAC Equipment.
Bidder's List View project details and contacts
Prospective Bidders View project details and contacts
Project Documents
 Engineered Spec Sheet
 Architectural Plans
 Other Documents