Sea Bright to Manasquan, NJ, Project

2-Sea Bright to Manasquan, NJ (Beach fill) The Federally authorized Sandy Hook to Barnegat Inlet Beach Erosion Control Project is located on the Atlantic Coast of New Jersey, covering 51 miles of coastline between Sandy Hook peninsula and Barnegat Inlet. The Project report recommending Federal action was submitted it to Congress in 1956 and authorized by the River and Harbor Act of July 3, 1958, in accordance with House Document No. 332, 85th Congress, second session. Further modifications associated with the non-Federal sponsor cost share and public access requirements were made by Section 854 of the Water Resources Development Act (WRDA) of 1986, (P.L. 99-662). The project area is comprised of three sections and is further sub-divided by construction contracts. Section I and Section II are within New York District's jurisdiction, which extends 21 miles from just north of the Route 36 Bridge in Sea Bright, southward to the Manasquan Inlet. The FY19 renourishment Project plan is for fill only, including advanced nourishment along the length of the design berm, from Sea Bright to Long Branch, NJ. The approximate volume quantity is 2.4 million cubic yards, and award will be in the fourth quarter of FY19. The recommended plan provides for reduction of storm damages from coastal erosion and flooding through storm protective berm and beachfill. The State of New Jersey, acting through the Department of Environmental Protection, is the non-Federal sponsor for this project

Division 31 -	Earthwork, Erosion and Sedimentation Controls.
Division 33 -	Utilities, Storm Drainage Utilities, Ponds and Reservoirs.
Division 35 -	Waterway and Marine Construction, Shoreline Protection, Waterway Construction and Equipment.