Air Force Band Studio Audio System Updates

Concert Band Studio and Singer’s rehearsal studio: Remove old console, desk and rack. A new console will be installed in a custom desk alongside a 46 space equipment rack. Rack to be assembled and loaded with new and existing equipment. All equipment to be patched. Three cat6, two 50 ohm BNC and two 75 ohm BNC lines to be run through existing cable path and conduit from the concert band hall to the singer’ studio across the hallway and terminated. RF Antennas mounted in both the Hall and studio 4rea4 Controller and A-168 stage rack to be mounted in the Singer’ Studio Max Impact Studios: Remove old console, desk and rack. A new console will be installed in a custom desk with equipment racks below. Equipment in the rack to be loaded and properly patched. Take down existing four loudspeakers from the ceiling and remove old wiring and rigging. Install four loudspeakers from the ceiling and subwoofers on the ground Install new speaker patch plates in the wall and run cable from the plates to the speakers in the ceiling. Airman of Note Studio: Remove old console, desk and rack. A new console will be installed in a custom desk with equipment racks below. Equipment in the rack to be loaded and properly patched. Take down existing four loudspeakers from the wall and remove old wiring and rigging. Mount four loudspeakers on the walls Install new speaker cable from rack in custom desk to the loudspeakers. This may require surface mount wire molding. Install speaker connection plates on the wall for future subwoofers Existing hardware in studios includes but is not limited to Sennheiser, Digico, Klang, l'acoustics, and Wisycom.

Division 27 -	Communications, Common Work Results for Communications.
Division 28 -	Electronic Safety and Security, Common Work Results for Electronic Safety and Security.