Similar Projects
Last Updated | 05/06/2019 02:01 PM |
Project Title | 8X10X4 Manhole Vault |
Physical Address | View project details and contacts |
City, State (County) | TX (Brazos County) |
Category(s) | Sewer and Water |
Sub-Category(s) | Sanitary Sewers |
Contracting Method | Competitive Bids. |
Project Status | Results |
Bids Due | View project details and contacts |
Estimated Value | |
Plans Available from | |
Owner | View project details and contacts |
Architect | View project details and contacts |
Description | Manholes shall have a minimum of a 42" hole opening. Ladder ups will be mounted in the center of every ladder. All 600 amp T-bodies and 200 amp elbows will have test points. All manholes will be clean at the completion of the project. Stabilizing sand shall be used for installation of all manholes. A minimum of 10 feet of rigid conduit with galvanized bell ends shall be required on each duct bank coming in and going out of the manhole. Alt conduits shall be cut off flush with the wall in the manholes. All electrical manhole covers shall be labeled with electric on the top of them. All cables shall be labeled with feeder number and bldg. numbers, cables should be marked with red and blue marking tape to identify the phases. Ail switches shall be anchor down and set so that it can be operated from manhole lid opening. Any position on the switch that is not used shall have a bushing well insert on the switch and a dust cover on the bushing and shall be grounded. Any terminations in the manhole shall be supported between the rack in the manhole and as close the wall as possible. All empty ducts coming into manholes shall be sealed off. All fire taping shall be wrapped with cloth taping (3M 77cloth tape). All ducts shall be swapped before sealing or pulling cable and shall have a pull string in each conduit. All racks shall be as high as possible in manhole All racks and rack arms shall be fiber glass Tie wraps shall be 3' in length and VS" in width Manhole lids shall be 4" above final grade. Iron castings for manhole rings and covers shall conform to ASTM A48, Class 30, and be traffic rated | ||||
Details |
|
||||
Bidder's List | View project details and contacts | ||||
Prospective Bidders | View project details and contacts | ||||
Project Documents |
Engineered Spec Sheet Architectural Plans Other Documents |