RFQ - Various Phase I/II Engineering Projects, Various Routes

Job No. P-93-029-22, Various Phase I/II Engineering Projects, Various Routes, Various Counties, Region Two/District Three. This project requires 23% DBE participation, or if the contract goal is not met, documented evidence of good faith efforts. The Complexity Factor for this project is 0. The Consultant who is selected for this project and all Subconsultants the Prime Consultant will be using are scheduled to attend an initial meeting on July 28, 2022, at 10:30 AM at the Region Two/District Three Office in Ottawa. Phase I and/or II engineering is required for various projects throughout District Three. Work orders under the blanket agreement will be negotiated and authorized by the department on an as-needed basis. Phase I engineering studies, if required, may consist of conducting route surveys, land surveys, hydraulic analysis and reports, geometric studies, environmental studies, safety studies including crash analyses, preparing project reports, and reviewing geotechnical reports. This work may include data collection, development of alignment alternatives, cost estimates, traffic management analysis, crash analysis, bridge condition reports, TS&L drawings, and other related work and exhibits necessary to complete the Phase I preliminary engineering. It is anticipated that this contract will include approximately three (3) to fifteen (15) different projects with estimated construction costs ranging up to $10,000,000. The engineering services required may consist of only a portion of the total engineering work on a certain project. The estimated engineering fee for this project is $1,000,000. The completion date for this contract will be 60 months after authorization to proceed. The Prime firm must be prequalified in the following categories to be considered for this project: Highways (Roads and Streets) Location Design Studies (Rehabilitation) Statements of Interest, including resumes of the key people noted above, must be submitted electronically to the Central Bureau of Design and Environment through the Engineering Prequalification and Agreement System (EPAS). The firm acting as the prime must be prequalified in all the prequalification categories requested in the project advertisement even if they plan to subcontract part of the project, except where noted in a specific project advertisement. Any work being done by a consultant, prime or sub must be prequalified in the IDOT prequalification category of work they are performing. Questions concerning this Bulletin should be directed to: E-mail: DOT.ConsultantServices@illinois.gov Or mailing address: Bureau of Design and Environment 2300 South Dirksen Parkway Attn: Consultant Unit Room 330 Springfield, IL 62764 The method of contractor selection has not been determined at this time. IDOT - 027 - RFQ - Various Phase I/II Engineering Projects, Various Routes

Division 01 -	General Requirements, Vehicular Access and Parking, Traffic Control, Temporary Barriers and Enclosures.
Division 03 -	Concrete, Concrete Reinforcing, Precast Structural Concrete.
Division 05 -	Metals, Structural Steel Framing, Structural Steel for Bridges, Steel Joist Framing, Steel Joist Girder Framing.
Division 07 -	Thermal and Moisture Protection, Expansion Control.
Division 09 -	Finishes, High-Performance Coatings.
Division 10 -	Specialties, Signage, Traffic Signage.
Division 26 -	Electrical, Exterior Lighting, Lighting Poles and Standards, Roadway Lighting.
Division 31 -	Earthwork, Embankments, Erosion and Sedimentation Controls, Slope Protection, Gabions, Riprap, Special Foundations and Load-Bearing Elements, Driven Piles.
Division 32 -	Exterior Improvements, Operation and Maintenance of Exterior Improvements, Bases, Ballasts, and Paving, Flexible Paving, Rigid Paving, Fences and Gates, Retaining Walls.
Division 34 -	Transportation, Operation and Maintenance of Transportation, Bridges.