Cave - Replace Well Pump

Similar Projects

Well No. 3 Replacement Phase 2
Bidding
Los Lunas, NM

Well No. 3 Phase 1
Post-Bid
Tijeras, NM 87059

Diagnose and Repair Water Well for Rural Community of Pine Hill
Post-Bid
Pinehill, NM

Drilling and Developing Replacement Water Well 40
Results
$963,498 est. value
Las Cruces, NM

H--NIIP B3.1 Pump Repairs
Results
Farmington, NM 87401

Pendaries Village Mutual Domestic Water Association - Two Supplemental Water Wells
New Construction
Construction
Rociada, NM

Jenkins Well Abandonment
Post-Bid
Santa Clara Pueblo, NM 87532

Drill/Install New Ground Water Monitoring Well Drilling/Installation of Ground Water Monitoring Well
Results
Thoreau, NM

2020 Well 6 Replacement Project
Post-Bid
Logan, NM 88426

On Call Well, Pump, Motor, and Maintenance Services
Results
Ruidoso, NM 88345

Equip Brandy Well 1, an Existing Well with a Solar Pumping System
Post-Bid
Cuba, NM 87013

Alto 2 Well (H-1979-S7) Improvements
Results
Ruidoso, NM 88345

Clean Frenchy I Well
Post-Bid
Alamogordo, NM 88310

Groundwater and Well Services
Results
Santa Fe, NM 87505

Corrales Trunk Collector Pipeline (CTCP) Phase 3 Corrales Well 2 Site Improvements and Corrales Reservoir Site and Arsenic Treatment System Improvements
Post-Bid
Albuquerque, NM 87102

Pumps and Wells Construction Project Lead, Carlsbad, NM 88220 (Eddy County)

Share

Last Updated	12/17/2019 03:54 PM
Project Title	Cave - Replace Well Pump
Physical Address	View project details and contacts
City, State (County)	Carlsbad, NM 88220 (Eddy County)
Category(s)	Sewer and Water
Sub-Category(s)	Pumps and Wells
Contracting Method	Competitive Bids.
Project Status	Results
Bids Due	View project details and contacts
Estimated Value
Plans Available from
Owner	View project details and contacts
Architect	View project details and contacts

Description

Work List: 1. Video camera inspect well. 2. Replace submersible well pump, motor, motor starter, control panel, and submersible pump wire. 3. Install pump Â¿run dryÂ¿, over/under current and voltage protection device. 4. Replace all drop pipe and couplings. 5. Replace check valves in drop pipe. 6. Replace motor saver and all associated wiring 7. Relocate, any existing equipment, wiring, plumbing, necessary to correct electrical code violations.

Details

Division 02 - Existing Conditions, Subsurface Investigation.
Division 03 - Concrete, Cast-in-Place Concrete.
Division 22 - Plumbing, Plumbing Piping, Plumbing Equipment.
Division 26 - Electrical, Instrumentation and Control for Electrical Systems.
Division 33 - Utilities, Water Utilities, Water Utility Distribution Piping, Water Utility Distribution Equipment, Water Utility Pumping Stations, Wells.
Division 44 - Pollution and Waste Control Equipment, Water Pollution Control Equipment.

Bidder's List

View project details and contacts

Prospective Bidders

View project details and contacts

Project Documents

Engineered Spec Sheet

Architectural Plans

Other Documents