Carter Traditional Elementary School Partial Roof Replacement

This project will replace approximately 291 squares of roofing on the DuValle Education Center portion of Carter Traditional Elementary School. Single or multiple contracts shall be awarded on the basis of the lowest and best lump sum bid, or on the lowest and best combination of individual bids, whichever is deemed to be in the best interest of the Jefferson County Public Schools. In addition to lowest and best bid, a minimum number of points may be required to be awarded for the General Contractor's Good Faith Efforts if District's goals are not met. (See Good Faith Effort Scoring System in M/W/VBE Program requirements) Bid Guaranty in the form of a Certified/Cashier's Check or Bid Bond shall accompany each bid. The amount of the Bid Guaranty shall not be less than five percent (5%) of the bid set forth on the Form of Proposal. The Bid Guaranty shall be made payable to Jefferson County Public Schools. The Bid Guaranty shall be issued by a Surety Company that has an A.M. Best Company rating of "A-" or better. Refer to Supplemental Instructions to Bidders. Absence of this document will be grounds for automatic rejection of bids. Certified or cashier's checks will not be returned until Board approval of the successful bidder. Refer to spec section "JCPS Amendment to the General Conditions of the Contract for Construction" for requirements for 100% performance and payment bonds. Bids may not be withdrawn for a period of 45 days after the designated time for receipt of bids. Contractor's Profile form, if not currently on file, is due prior to award of a contract. The Jefferson County Board of Education provides equal opportunities to all of its bidders with respect to the bidding and award of construction contracts. The Owner reserves the right to accept any bid, reject any or all bids, to waive any informalities in bids received where such acceptance, rejection or waiver is considered to be in the best interest of the Owner, and to reject any bid where evidence or information submitted by the bidder does not satisfy the Owner that the bidder is qualified to carry out the details of the contract documents. 1. Remove existing roofing, roof insulation, gravel stops, fascia, and expansion joints. Remove roof ventilators, ductwork, during reroofing. Do not split corners or turn up counter flashing. 2. Inspect all Roof Drains, Gutters, Downspouts, and interior piping for leaks before demolition starts. Report any damage or leaks to owner and Architect prior to roof installation. 3. Replace any deteriorated wood nailers, install new nailers (blocking), fascia, as necessary. Install new, or raise existing curbs, nailers, ducts, electric lines, etc., as necessary for a minimum height of 10" above finish roof surface. 4. Roofing Type I, Existing Concrete Deck, Primer, 2ply mopped and glazed (temp. roof), 2 layers Rigid insulation to achieve minimum "LTTR25", Cover board, Modified Base Sheet, Modified Cap Sheet with Granule Surface. 5. Roofing Type II, Existing Concrete Deck, Poured Light weight concrete, Primer, 2ply mopped and glazed (temp. roof), 2 layers Rigid insulation to achieve minimum "LTTR25", Tapered Insulation 1/8" per FT. slope, Cover board, Modified Base Sheet, Modified Cap Sheet with Granule Surface. 6. Install base flashing. Install pressure bar at top of all base flashing. Install leader heads, downspouts, scuppers, counterflashing.

Division 07 -

Thermal and Moisture Protection, Dampproofing and Waterproofing, Thermal Protection.