Jail Door Replacements and Repairs

The Work is for repair and/or replacement of the Dayroom doors various blocks of the old jail. 1. A-block entrance door: Remove existing worn Folger Adam 80 series lock and 2. furnish and install one new Folger Adam 80 series lock with four new keys. Repair 3. damaged door closer arm mounting holes and install mounting screws; 4. C-Block entrance door: Remove existing worn #5 hinges. Furnish and install two new 5. #5 hinges. Spread lower section of frame and weld/anchor steel straps to hold position 6. to allow for door clearance in frame; 7. D-Block entrance door: Remove existing worn Folger Adam 80 series lock and 8. furnish and install one new Folger Adam 80 series lock with four new keys; 9. E-Block entrance door: Cut bottom hinge off frame, realign and weld on frame to stop 10. door from rubbing frame and provide door clearance; and 11. Prime paint on areas of work only. Replace the five existing J Bock holding cell doors, frames, and hardware that have been damaged due to rust and water from flooding. This includes holding cell #1, 2, 3, 4, and 5 in J Block. The new frames and doors will be of same size and style as existing. These new doors will not a speak-thru like the existing doors. 1. Remove existing doors, frames, and hardware for holding cells 1-5. Dispose of offsite; 2. Furnish and install (5) 12 ga. Galvannealed Detention Hollow Metal Frames 3. approximately 28” x 88” for cells 1-5; 4. Furnish and install (5) 12 ga. Galvannealed Detention Hollow Metal Doors 5. approximately 23 3/4” x 83” for cells 1-5; 6. Furnish and install (3) 41/2” x 41/2” new detention grade full mortise stainless steel 7. hinges for cells 1-5; 8. Furnish and install (1) Southern Steel 1080 series detention dead bolt lock in door for 9. cells 1-5; 10. Furnish and install (1) 12” x 8” piece of detention grade glazing in cell doors 1-5; 11. Furnish and install (1) detention loop door pull on the outside and (1) detention door 12. flush pull on the inside of the cell doors 1-5; 13. Furnish and install (1) 15 1/2” wide x 5” tall food pass in each cell door. Food pass will 14. be secured with a Southern Steel 1017A snap-latch lock; and 15. Furnish and install one steel hinged shutter/cover with snap-latch for the glass in doors 1-5.

Division 08 -

Openings, Doors and Frames, Windows.