FPR ATCT Fire Alarm System Replacement

1. Installing a new fire alarm system side-by-side to the existing Simplex 4100U fire alarm system. The existing system shall remain fully operational until the new system is installed, inspected, tested, commissioned and accepted. 2. Connecting and interfacing the new fire alarm system to the existing emergency control function interface device circuits, once the cutover plan is approved. 3. Removing and replacing the existing transient voltage surge suppression. Devices (TVSS) and installing new TVSS’s on fire alarm system equipment and circuits in accordance with FAA requirements. 4. Conducting a 100% acceptance test in accordance with NFPA 72, National Fire Alarm and Signaling Code by functionally testing / operating every initiating device, notification appliance and emergency control function interface device for proper operation and annunciation. 5. Removing and demolishing off-site the existing fire alarm system equipment, conduit and wiring that is not reused. 6. Permanently securing smoke damper louvers in the open position for the two fire/smoke dampers installed as part of the stair pressurization system shaft located on the Intermediate Level 1 of the ATCT. 7. Firestopping all new penetrations made to accommodate new or removed conduits, wireways or other equipment, so that the rating of the enclosure is maintained. 8. Painting and patching in accordance with the Contract Documents to the satisfaction of the FAA.

Division 21 -	Fire Suppression.
Division 28 -	Electronic Safety and Security, Fire Detection and Alarm.