Ejector Pump at Fairfield ES

Provide all labor and materials necessary to install a fully functioning ejector pump as follows: Install (1) new 3”, 230V, 2 HP, 1 PH ejector pump with approximately 10’ of 3” copper pipe, (1) 3” ball valve, (1) 3” male adapter, (1) 3” soil adapter, (1) 3” union (1) 3” 90 and (1)3” 35. Install (1) new Nema 4x simplex control panel equipped with (3) mechanical float switches. Install (1) 2” 110 volt submersible ejector pump including a integral switch to serve as a back-up pump providing approximately 10’ of new 2” copper pipe, (1) 2” ball valve, (1) 2” union, (1) 2” 90, (2) 2” male adapters, (1) 2” swing check and (1) 2” 45. Furnish and install (1) 208V feed and (1) 120V feed from utility vault from the main building to the boiler room (approximately 300’+). -Replace damaged disconnect with 2 pole and provide, NEMA 3R weatherproof disconnect switch. Replace damaged 120V receptacle, and provide conduit and wire with new GFCI receptacle in weatherproof box.

Division 02 -	Existing Conditions, Subsurface Investigation.
Division 03 -	Concrete, Cast-in-Place Concrete.
Division 22 -	Plumbing, Plumbing Piping, Plumbing Equipment.
Division 26 -	Electrical, Instrumentation and Control for Electrical Systems.
Division 33 -	Utilities, Water Utilities, Water Utility Distribution Piping, Water Utility Distribution Equipment, Water Utility Pumping Stations, Wells.
Division 44 -	Pollution and Waste Control Equipment, Water Pollution Control Equipment.