Water Tower

300,000 Gallon Spheroid Exterior Overcoat, Dry Interior Partial Repaint and Miscellaneous Repairs. Exterior: High pressure water clean (5,000 to 10,000 psi), spot power tool clean to a SSPC-SP11 standard, and apply a three (3) coat epoxy urethane system. Dry Interior: Abrasive blast clean the entire tops of the platforms (including 1 ft. up the riser wall), the entire bowl, the bottom ½ of the access tube, and spot failures throughout to a SSPC-SP6 commercial standard. Apply a three (3) coat epoxy system to the bottom ½ of the access tube and the entire bowl and a spot two (2) coat epoxy system to the rest of the prepared surfaces. Pit Piping: Abrasive blast clean to a SSPC-SP6 commercial standard and apply a two (2) coat epoxy system. Foundation: Repair grout and repair spalls. Water clean and apply a two (2) coat epoxy system. Repairs: Install a gasket on the wet interior roof hatch. Replace the access tube roof hatch. Install ladder extension at the condensate platform. Install deflector bars on the fill/draw pipe. Overflow discharge modification. Install a condensate drain line and a kickplate around the overflow opening. Install a mud valve. Replace roof vent screen. Install a seal at the access tube air gap. Install a roof handrail with a painter’s rail. Replace dry interior and aviation light bulbs. Weld a rigging lug on the bowl. Weld a pipe at the roof antenna cable penetration. Install a sample tap on the fill/draw pipe.

Division 02 -	Existing Conditions, Subsurface Investigation.
Division 03 -	Concrete, Concrete Reinforcing, Cast-in-Place Concrete.
Division 05 -	Metals, Structural Metal Framing, Metal Decking.
Division 23 -	Heating, Ventilating, and Air Conditioning (HVAC), Facility Fuel Piping, Facility Fuel-Storage Tanks.
Division 31 -	Earthwork, Clearing and Grubbing, Grading.
Division 32 -	Exterior Improvements, Fences and Gates.
Division 33 -	Utilities, Storm Drainage Utilities.