Install New Shower Stall B4897

The work includes installation of a shower stall, plumbing and incidental related work. Contractor shall provide and install a shower stall located in Toilet Room 102 in Building 4897. Reference Worksite Building 4897 and As Built Drawing NAFAC #12587712. The shower stall shall be CSA B45.5-17/IAPMO Z124 four piece white solid acrylic pressure molded fiberglass reinforced plastic shower stall enclosure with door. Shower stalls shall be scratch resistant, waterproof, and reinforced. Provide shower curtain rod and privacy shower curtain. Provide recessed type shower stalls approximately 36 inches wide, 36 inches front to rear, 76 inches high, and 5 inch high curb with shower stall bottom or feet firmly supported by a smooth level floor. Provide PVC shower floor drains and stainless steel strainers. Contractor shall be demoing concrete floor to install the shower stall drain to the existing sanitary sewer. The new concrete to cover the drain shall be rated for 3500 psi. Shower stalls shall meet performance requirements of CSA B45.5-17/IAPMO Z124 and shall be labeled by NAHB Research Foundation, Inc. for compliance. Install shower stall in accordance with the manufacturer's written instructions. Finish installation by covering shower stall attachment flanges with dry-wall in accordance with shower stall manufacturer's recommendation. Provide smooth 100 percent silicone rubber white bathtub caulk between the top, sides, and bottom of shower stalls and bathroom walls and floors.

Division 09 -	Finishes.
Division 10 -	Specialties, Compartments and Cubicles, Shower and Dressing Compartments.